Eflight 30 amp esc manual

The default settings (from the package) for your E-flite Amp Pro ESC are as follows: • Voltage cutoff set at 74% • Brake set to Off • Timing set at 15 degrees • Throttle Input Range set at ms to ms • Start-up Rate (Acceleration Delay) set at seconds • PWM Frequency set at 8KHz • Operating Mode set to normal (airplane). The 60 AMP Brushless ESC by E-flite is built for optimal functionality and high performance flying. Shop RC plane accessories and more remote control products at Tower Hobbies. STEP 6: ESC SETUP BRAKE FUNCTION: The factory default brake setting is “off”. Skip to the “ESC OPERATION” section below if you want to keep this setting. To turn the brake “on”: 1. Move the throttle stick to full throttle, turn on the transmitter and connect the battery to the ESC.

E-flite Amp Pro Switch-Mode BEC Brushless ESC V2: EC3, EFLAB. The E-flite® Amp Pro Switch-mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. The default settings (from the package) for your E-flite Amp Pro ESC are as follows: • Voltage cutoff set at 74% • Brake set to Off • Timing set at 15 degrees • Throttle Input Range set at ms to ms • Start-up Rate (Acceleration Delay) set at seconds • PWM Frequency set at 8KHz • Operating Mode set to normal (airplane).

You can drive up to 7 analog or 6 digital standard-sized servos with theBEC on any recommended input voltage. This ESC also features an exposed,finned heat sink. PLEASE READ THESE INSTRUCTIONS IN THEIR ENTIRETY BEFORE USE. Before you connect your ESC and begin flying, take a moment to look it over. servos with the BEC on any recommended input voltage. This. ESC also features safe power arming along with advanced programmable features such as low voltage.